|
|
(Your shopping cart is empty)
| |
0 of 0 people found the following review helpful: |
| |
 |
 |
 |
 |
Awesome! |
April 23, 2010 |
| Reviewer:
Eric Smith
from Booneville, KY United States
|
|
These can make the differance between a good rifle and a excellent rifle!
Was this review helpful to you?
|
 |
 |
 |
 |
|
| |
0 of 0 people found the following review helpful: |
| |
 |
 |
 |
 |
Nice |
April 5, 2010 |
| Reviewer:
Matthew Palmer
from Mary Esther, FL United States
|
|
It was a pain in the ass to install, once you put the Crane O-Ring over the estractor it increases the extractor tension so much that it is hard to press the down far enough to put tie extractor pin back in. I was very impressed by this, you know the extractor is not goinh to slip off the case rim during extraction. Thos product is a must for Duty/Combat Rifles. I 'm going to pur them in all of my AR's
Was this review helpful to you?
|
 |
 |
 |
 |
|
| |
0 of 0 people found the following review helpful: |
| |
 |
 |
 |
 |
Just do it! |
September 29, 2009 |
| Reviewer:
Robert Brooks
from Philadelphia, PA United States
|
|
This was my first M16 failure. Will never forget it. Just a few dollars for so much security. Just do it!
Was this review helpful to you?
|
 |
 |
 |
 |
|
| |
11 of 11 people found the following review helpful: |
| |
 |
 |
 |
 |
It Runs !! |
May 15, 2007 |
| Reviewer:
Mike S.
from Tempe, AZ United States
|
|
I had a short barrel M16 that was real tempermental on how it would run. Lots of jaming with one live round and one fired brass case. I was told to get this BCM spring kit and a heavier buffer. Got both from Bravo (fast shipping) and this thing is running 100% !!! I wish I knew about this upgrade years ago. I am going to order more for spares.
Was this review helpful to you?
|
 |
 |
 |
 |
|
|