Direct Attach to KeyMod™ Version
length for increased mobility and decreased “snag” factor.
forward angle increases the rigidity of the forearm, while providing a
more natural wrist angle.
be mounted in reverse angle to increase control when grabbing handguard
sides with aggressive texture give better yaw control to the shooter
during firing and non-firing manipulations.
and bolt system offers a simple robust design, while maintaining a
lightweight 1.9 ounces.
in the U.S.A., manufactured from high quality, impact resistant polymers.
Tools needed: T15 Torx Driver (not supplied)
tool (T15 Torx™ driver) into the screw from under the BCM® KeyMod™ Vertical
tool into the screw to extend the KeyMod™ anchor, making it protrude from
the anchors in the two selected large holes of the desired KeyMod™ slots.
Grip can be installed in your desired orientation, angled forward or back.
the anchor is inserted, slide the BCM® Vertical Grip forward until it
travels no further.
- Push the
BCM Vertical Grip against rail, engaging the accessory’s recoil lugs to
the intersecting KeyMod™ opening.
the recoil lugs engaged, tighten the screw to snug the anchor
(approximately 40 Inch-lbs. plus quarter turn).
there is no wiggle or forward/backward movement once tight.
*Blue thread locker may be used on