Reviewer:
Phillip Hicks
from Bozeman, MT United States
I had to slightly modify this piece to fit a stag arms lower but that was a simple extra step and certainly isn't a problem with other lower recievers. If you can, re-use your old roll pin. It will make the install much easier. An essential upgrade for a guy that lives in montana and wears gloves almost year-round. You won't regret this one.
Was this review helpful to you?
0 of 0 people found the following review helpful:
Another Magpul winner
February 11, 2011
Reviewer:
James Collins
from Norwood, MA United States
Easy install, nice fit and finish what else can I say another winner for Magpul
Was this review helpful to you?
4 of 4 people found the following review helpful:
Buy these before your TG gets to you
November 12, 2010
Reviewer:
Anonymous Person
from Portland, OR United States
You will need a 1/8th punch or something similar. And also a 1/16th hex tool.
Was this review helpful to you?
1 of 1 people found the following review helpful:
use your old pins
March 22, 2010
Reviewer:
Shane
from monterey, CA United States
Mike Magliaro: your so right about the pins. I installed mine today and boy, it was so hard to punched the pin. I even use lube but i still had a hard time to putting the pins on. Magpul should provide consumers with an allen wrench to go along with the screw, but other than that great product...
Was this review helpful to you?
0 of 0 people found the following review helpful:
Great
February 17, 2010
Reviewer:
Wilson5831
from Tucson, AZ United States
Matched up great to 3 different ARs. Very easy to install and roll pins and screws went in fine.
A great guard. 
Another Magpul winner 