The improvements of the IMod are as follows: Integral, but removable non-slip buttpad (color matched to stock components)
- Rolled/angled buttpad toe with wide traction area. This will assist in running the stock high on shoulder, making the IMod system more user friendly when using web-gear and/or body armor.
- Improved lock paddle, making it easier to operate and making the contact surface non-slip when operating the lever.
- Removed most sharp edges that may cause “snag points” to web-gear or other vital equipment.
- Improved strength throughout construction of the stock chassis. This will provide maximum strength during “Mortaring exercise” or unexpected impact.
IMOD at a glance:
||Removable rubber buttpad and storage compartments. A true Modular buttstock for the AR15/M16/M4 carbine series.|
||Impact and temperature resistant polymer, specially blended for Vltor. Metal components are either carbon steel or stainless steel (depending on the application)|
||Milspec IMods will only fit receiver extensions/buffer tubes with the outer diameter of 1.150”.|
|Weight - Nominal
||Less than 9.4 oz. (with storage compartment and buttpad installed)|
Length: 6.250” (without buttpad)
Length: 6.626” (with buttpad)
Width: 2.500” (with storage compartments installed)Height: 5.210” (with buttpad installed)
||All stocks have a matte (anti-reflection/glare) finish. IMods are only available in the following colors: Black, Flat Dark Earth (Tan) and Foliage Green. Foliage Green is more of a “grey” green versus Olive Drab.|
Storage capacity: Each side compartment can hold at least two AAs or three lithium CR123 3-volt batteries. The internal diameter of each compartment is 0.685”.Sling mounting: All Modstocks, including the IMod will accept a push-button, quick detachable sling swivel or a conventional web sling, measuring up to 1.375” in width. .
The compartment has a bore, accessible from either end, which will house any item measuring no more than 0.680 of an inch in diameter. The bore dimension was specifically developed to access the 3-volt lithium battery most commonly used in tactical flashlights. The compartment is enclosed on both ends with water and element resistant locking caps, which seals the compartment's bore.
The Modstock system is made from a special glass filled nylon and metal components. The nylon has been specially formulated to be lightweight, high strength and impact, temperature, and chemical resistant. The metal components are stainless steel or quality carbon steel, finished in manganese phosphate to a MIL-SPEC standard.
This stock is made to fit over your Mil-Spec dimention receiver extention. (Colt, Vltor, BCM, CMT, LMT, Stag Arms)
As this stock was originally designed as a military replacement/upgrade to the USGI Colt M4 stock, it is made to Mil-Spec dimentions. It will not fit on commercial dimention receiver extentions.
This product includes:
Compartment Caps and Compartment Mounting Hardware
Not Included: Mil-Spec receiver extention, end plate, lock nut, buffer, action spring