Home > BCMGUNFIGHTER™ Vertical Grips >

BCMGUNFIGHTER KAG - KeyMod™ - Flat Dark Earth

BCMGUNFIGHTER KAG - KeyMod™
BCMGUNFIGHTER KAG - KeyMod™


 
Alternative Views:


List Price: $21.00
Our Price: $18.95

Stock Status:In Stock
Product Code: BCM-KAG-KM-FDE
Qty:

Description
 

BCMGUNFIGHTER™ KAG-KM

Kinesthetic Angled Grip - KeyMod Version

The KAG is the end result of collaboration between BCM® and Travis Haley, founder of Haley Strategic Partners and inventor of multiple weapons manipulation enhancements in the firearms industry.

Designed to complement modern shooting grips, the Kinesthetic Angled Grip (KAG) uses a biomechanically efficient forward rake to create an interface for positive retention and joint relief to the wrist, elbow, and shoulder, allowing for smooth weapon manipulation without substantial increase to the girth of the weapon system. Textured on both front and back, the profile of the KAG creates a channel for consistent and positive engagement which translates directly into improved efficiency in weapons manipulation and target to target transitions.


• Forward rake gives positive retention when using “C-clamp” (thumb over bore) method of handguard support

• Works as a rest for supported firing positions

• Slight angle without significant bulk adds just the right amount of relief to the wrist without substantially increasing the girth of the handguard

• Small profile is just enough to get repeatable hand position on weapon for-end

• Innovative patent pending attachment method allows for robust clamping and alignment with minimal hardware and slender accessory size

• Textured in front and back for positive engagement

• Made in the U.S.A. from high quality, impact resistant polymers.


Installation Instructions - Tools needed: T15 Torx Driver (not supplied)


• Insert tool (T15 Torx™ driver) into the screw from under the BCM KeyMod™ KAG Handstop

• Push tool into screw to extend the KeyMod™ anchor, making it protrude from the top

• Align the anchors to the two selected large holes of the desired KeyMod™ slots

• After the anchor is inserted, slide the KAG Handstop forward until it travels no further

• Push the Handstop against rail, engaging the accessory’s recoil lug to the intersecting KeyMod™ opening

• With the Recoil Lug engaged, tighten screw to snug the anchor (approximately 40 inch-lbs. plus quarter turn*DO NOT OVERTIGHTEN*)

• Ensure there is no “play” or forward/backward movement once tightened.


*Blue thread locker may be used on threaded fasteners


Average Customer Review: 5 of 5 Total Reviews: 55 Write a review.

  0 of 0 people found the following review helpful:
 
You know June 4, 2019
Reviewer: David Sanders from Cabot, PA United States  
Superb!

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
June 4, 2019
Reviewer: John Crouse from Trabuco canyon, CA United States  
Excellent product as usual from BCM. I run BCM butt stocks exclusively and the KAG handstop is the same great quality!

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Perfect June 4, 2019
Reviewer: Fernando from Naples, FL United States  
The right size without encroaching into other areas of the riffle. It is a small piece just to create enough support - I installed it toward the back of the guard since I was used to gripping my riffle at the magazine well.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Very Good May 8, 2019
Reviewer: Plissken from Bellevue, WA United States  
Overall, the KAG is very good.  I switched over from an angled grip from a certain other manufacturer because I felt I couldn't quite get the necessary grip on the rail to correctly hold the rifle.  The grip is comfortable, and I can know generate pressure in the proper manner.

I subtract one star for the KeyMode system.  Frankly, it's a bit screwed up.  I'm mechanically inclined, and I had to fumble with it a bit.


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Interesting April 10, 2019
Reviewer: Jordan C from Midland, MI United States  
I must say I wasn't sure what to expect as I've only ever used vertical grips. To my delight, I have found this is a nice median between a vertical grip and the traditional flat rail grip. So far I have been pleased with it.

Was this review helpful to you?

View All Customer Reviews

Browse for more products in the same category as this item:

BCMGUNFIGHTER™ Vertical Grips
Stocks, Grips, and Handguards: Vltor, Magpul, Tango Down, etc > Vertical Fore Grips
Stocks, Grips, and Handguards: Vltor, Magpul, Tango Down, etc
KeyMod™ Accessories